Motovox MVS10 Bedienungshandbuch PDF herunterladen (Seite 7)

FUELING

STARTING

PACKAGE CONTENTS

IINITIAL SETUP

The MVs10 uses a two-stroke engine. Always run

the engine using a fuel mixture of gasoline with the

proper amount of 2-cycle engine oil.

Please read instructions below before fueling.

1. Mix fuel (minimum 87 octane) and 2-cycle engine

oil in a separate container. Use a good quality 40:1

ratio 2-cycle oil. Make sure the fuel is well mixed by

shaking the container before lling the fuel tank on

the scooter. Be sure and mark the container visibly that it contains oil/gas mix.

2. Make sure that the engine is not running.

3. Open the fuel cap slowly, so that possible pressure build-up can be released.

4. Wipe o the fuel cap area to make sure that it is free of dirt and debris.

5. Pour pre-mixed Gas/Oil mixture into the fuel tank being careful not to overll.

6. After fueling, replace the fuel cap and tighten.

7. clean any spilled fuel o the tank and engine.

Never try to mix the oil and gas in the MVs10 Fuel tank,

always mix it well in a separate fuel container rst.

Move at least 10 feet away from where you lled up the tank to get

away from spills and fumes.

1. Set the choke to the ON (up) position.

2. Turn the key to the ON position.

3. Press the fuel primer bulb several times until you see fuel in the bulb.

4. Holding the left hand grip, pull the starter briskly. Note: Do not allow it to snap

back, instead, let it recoil slowly.

3. You may want to give it a little throttle by gently squeezing the thumb throttle.

4. It may be necessary to pull start the motor several times the rst time you start it.

5. Once the engine has started and run for 20 seconds, move the choke lever down

to the OFF position.

6. Let the engine warm up for a minute before riding.

Your Motovox MVs10 comes with the following items in the shipping carton.

When opening the carton for the srt time, be sure you have the following items:

1. MVs10 Stand-up Scooter

2. Tool set

3. Owners Manual

Please read and follow these instructions carefully!

1. Carefully remove the MVs10 from the carton.

2. To unfold the MVs10, begin by pressing down on the FOLDING LEVER with one

hand (see below) while gently pulling up on the steering tube with the other.

3. Fully extend the steering tube to its upright position until you feel the mechanism

lock into place.

4. When you rst take the MVs10 out of the box, the HANDLEBARS are not clamped to

the steering tube in order to save space for shipping. Place the handlebar clamp over

the steering tube, taking care to position them as straight as possible. Then, using the

allen wrench found in your tool kit, rmly tighten the tension bolts in the clamp.

Do not pull cables!

GETTING STARTED MIXING FUEL

98 OPERATING CONTROLS

Fuel Tank

Folding steering tube

Handlebar clamp

Locking folding lever

Handlebar assembly

TROUBLE? DO NOT RETURN TO STORE contact us! 888-488-MOTO (6686) or email [email protected]

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare

Motovox MVS10 Bedienungshandbuch Seite 7

Kommentare zu diesen Handbüchern