Motovox MVS10 Bedienungshandbuch Seite 6

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 19
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 5
The operating controls of the MVs10 are relatively simple, but a rider
must to be able to operate the throttle, brakes and other controls without
stopping to look at them. Please study the image below carefully to
become familiar with the function and the location of each control.
Engine Kill Switch
Front Brake Lever
Rear Brake Lever
Thumb
throttle
Telescoping Steering
Tube Quick-Release
Lever
OPERATING CONTROLS
76 OPERATING CONTROLS
BEFORE STARTING
KEY SWITCH
CHOKE LEVER
FUEL PRIMER BULB
PULL STARTER
The Key Switch is located near the engine on the right
side of the scooter. The key switch is a good way to
keep unwanted users from riding the scooter as it
will not run without the key in the ON position.
Your MVs10 comes with folding keys so that it can
be folded out of the way when you ride. It is always a
good idea to store the extra key in a safe place.
Before starting your MVs10, you must be sure that the key switch is in the ON
position, the choke is in the ON position and that there is fuel in the primer button.
The locations and operation information of each of these controls in shown below.
The Choke Lever is located on the left side of the
engine and is used to start the engine when it is cold.
It is used to restrict the amount of air in the fuel mix-
ture to start easier and warm up. Flip the lever up to
the ON position to start, and then as the engine warms
up move the lever down to the OFF position.
The Fuel Primer Button is used to start the ow of fuel
to the carburetor and is located below the choke lever
under the carburetor. It is made of soft clear neoprene
to allow you to see the fuel in the line. Use your nger
to push it a few times when the engine is cool until you
see fuel passing through it.
The Pull Starter is used to start the engine. To start the
engine after you have conrmed the readiness of the
above three components, stand on the left side of the
scooter holding the left hand grip rmly. Using your
right hand, pull up sharply on the pull start grip to
spin the motor.
OPERATING CONTROLS
Key Switch
Choke Lever
Fuel Primer Bulb
Pull Starter
TROUBLE? DO NOT RETURN TO STORE contact us! 888-488-MOTO (6686) or email [email protected]
Seitenansicht 5
1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare