Motovox MVS10 Bedienungshandbuch PDF herunterladen (Seite 13)

MAINTENANCE PROCEDURES MAINTENANCE PROCEDURES

2120 MAINTENANCE

DRIVE CHAIN MAINTENANCE

ADJUSTING THE IDLE SPEED

The idle speed is the RPMs of the engine when it is at idle, or not being

accelerated. If the idle speed is too low the engine is running to slowly and

can die when you are stopped. If the idle speed is too high the scooter won’t

stay still when idling and may try to move forward.

To adjust the idle speed, locate the

idle speed set screw that is behind

the air lter housing on top of the

carburetor. Using a at or phillips

screwdriver and with the engine

running, turn the screw in (clockwise)

to raise the idle speed and out

(counter-clockwise) to lower the idle

speed.

Be sure to have a friend hold the scooter brakes while you adjust

the idle speed so it doesn’t move forward unexpectedly.

The fuel tank on the MVs10 must be kept clean to keep the engine running

smoothly and eciently. Over time, sediment can build up in the tank and

get caught in the inner workings of the carburetor causing clogs and poor

performance. To help avoid contamination and sediment build-up be sure

to always wipe o the area around the fuel cap before you open it, as well as

the spout of your fuel container

before pouring in fuel.

Locate and remove the two tank

mounting bolts behind the fuel tank.

Leaving the hoses connected, remove

the cap and pour out the contents.

Add some clean fuel, replace the cap

and swish it around a little. Then

remove the cap and pour it out.

Replace the tank to its mount and

re-ll the tank with clean, mixed fuel.

The drive chain needs periodic maintenance to protect it from premature

wear and from coming o while riding if it becomes too loose. The drive

chain should have a little bit of slack in it, approximately 1/4” movement in

either direction or about 1/2” total movement.

With the engine o, locate the drive

chain behind the chain guard on the

right side of the scooter. Press on it

from the top to see how much slack

is in the chain. If it has more than

1/2” of movement then your chain is

probably too loose.

To adjust the tension of the chain,

loosen the rear axle nut on both sides

of the wheel. Then, using a 10mm

open end wrench, screw the adjuster

nut in (clockwise) a few turns. Be sure

to adjust the same amount on both

adjuster nuts to keep the rear wheel

straight. Check the tension on the

chain again and repeat as necessary

until the chain feels right, then tighten

the axle nuts on both sides to hold it

in place.

To lubricate the chain, raise the rear

of the scooter up onto a block or

platform so that the rear wheel spins

freely. Then using one hand, spin the

rear wheel while spraying lube onto

the drive chain. Any standard lube

will work, but do not use a lube with

a degreaser in it, like WD40 because

it tends to dissolve the lube that is

inside the rollers, shortening the life

of your drive chain.

CLEANING THE FUEL TANK

Mounting bolts

Axle nut

Adjuster nut

TROUBLE? DO NOT RETURN TO STORE contact us! 888-488-MOTO (6686) or email [email protected]

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare

Motovox MVS10 Bedienungshandbuch Seite 13

Kommentare zu diesen Handbüchern