Motovox MVS10 Bedienungshandbuch Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 19
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
If the engine fails to start after repeated attempts, it may mean that it is
ooded with excess fuel. A common indication of a ooded engine is a
strong smell of fuel around the scooter. Follow the steps below to clear a
ooded engine.
1. Switch the choke lever to the OFF position.
2. Push the throttle all the way in to the full open position.
3. Move the key to the OFF position.
4. Using the pull starter, crank the engine over 10 or 15 times.
5. Move the key switch back to the ON position.
6. Start the scooter with the choke in the OFF position.
To stop the engine, press the kill switch located on the handlebars or turn
the key switch to the OFF position. The engine will stop.
Before riding this scooter, be sure that you have read and understand this
entire owners manual up to this point, including the sections that are titled
Important Safety Information and
Before You Ride. Even if you have
ridden other scooters in the past, take time to become familiar with how
this scooter runs and how it handles. Dierent scooters have dierent
handling characteristics. Always practice in a safe area until you feel
comfortable with how this scooter runs.
For your safety, NEVER run the engine in an enclosed
space
with poor ventilation, such as a garage. The exhaust contains poisonous
carbon monoxide which can collect rapidly and cause illness or death.
This scooter is not equipped with lights. Do not ride after dark.
1. Move the key switch to the ON position.
3. If the engine is cold, ip the choke lever up into the ON position.
If the engine is warm, you may not need to use the choke at all.
4. Stand on the left side of the scooter and hold the left hand grip.
5. Press the fuel primer bulb a few times.
6. Using your right hand, pull the starter handle upward sharply until it
starts, lowering the handle back to the recoiled position gently.
7. Once the engine starts to run, let it warm up by operating the throttle for
about 20 seconds, then move the choke lever down to the OFF position.
8. Let it warm up a little. Once the engine is warm, the idle will smooth out
and the scooter will be ready to ride.
NOTE: Extended running with the choke fully on will cause the engine to run
poorly and can cause damage to the spark plug and cylinder wall.
SAFE RIDING PRECAUTIONS
STARTING THE ENGINE
A FLOODED ENGINE
STOPPING THE ENGINE
The following section of the manual provides some basic information on
how to begin riding your MVs10 Stand-up Scooter. We will cover how to start
and stop the engine, how to use the throttle and brake and what you should
do when you nish riding.
BASIC OPERATION BASIC OPERATION
1312 BASIC OPERATION
Key Switch
Choke Lever
Fuel Primer Bulb
Pull
Starter
TROUBLE? DO NOT RETURN TO STORE contact us! 888-488-MOTO (6686) or email [email protected]
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare